2-6cm Automatic Banner Welding Machine Portable PE / TPO ECB / CSPE
specification parameters :
|Machine Name||Seamless LaserPVC , Flex , plastic Banner Welding Machine|
|Other name||Automatic Leister Heat air gun Plastic Welding machine|
|Heat air gun||Import Original 3400W Leister Heat Air Gun from Swiss|
|Voltage||110V / 240 V|
|Temperature scope||20 - 700 degree|
|Welding area||2-5 cm|
|Welding thickness||0.22 - 2 mm|
|Welding Type||automatic welding|
|Frequency||50 - 60 HZ|
1. Any part of this machine being bumped of fallen can cause some
damage impossible to be repaired.So please pay attention to carry
it.It is suggested to move the machine by manpower and put it down
2. Please check if there is damage or missed parts after unpack the
machine.Any problem, please contact us or the local agent
3. The place for installation must be flat and the floor is strong
enough to support the machine and moreover, the installation place
should close to power supply.
4. Keep the installation place no dust and avoiding sunshine.
5. Please sweep away the anti-rust oil from the machine with
detergent and re-lubricate with light lubricating oil after
1. Make the cloth for seaming flat and tight,. take joiner to
accurate (about 2-4cm),Fix both ends by tape or glue on ground.
2. set the temperature and walking speed: Connect the power supply,
set the temperature and walking speed according to the thickness of
the cloth. Temperature and speed is adjustable. As shown:
3. Turning the heating switch (yellow knob), the machine starts to
heat up. Wait for 2 minutes,when actual temperature (PV)approach
desire temperature(SV),we can start weld.
4. Welding positioning. Lap welding pressure(working wheels)- wheel
edge must be aligned with the upper edge of the banner
4.Lifting the handle, making the working wheel on ground,as the
6. start welding: pulling the heat gun to position handle and
making the nozzle close to ground then move the nozzle to left so
that it can be place a right position, at that time, the welding
will work automatic.
7. During welding,let hot air nozzle between two overlap pieces.
And be make sure hot air nozzle and Rubber wheel walk in straight
line.if not,please adjust by handrail.check photo:
8. finishing welding: when we finish these work, pull the handle
shake, turn right to move out nozzle until stops rotating nozzle
upwards and it is locks.
9. Turn off the switch: when finished, turn off the yellow
knob,shut off main power supply when the PV value is less than 50
degree.then we can turn off the power.
Thank you very much for choosing our “Automatic TOP-3400 banner
welding”. We believe that this will be your best choice for your
business. This equipment is designed professionally for ,sealing
film or foil and homogeneous coating and PE-coated webbing belt lap
welding that is make in PVC-P,PE,TPO ECB,CSPE,EPDM,PVDF. To help
you understand the characters features of this equipment and know
how to operate safely and keep in good condition etc.